Diesel generator start but not generate electricity inspection and processing methods:
1. Measure whether there is electricity, generator replacement voltmeter.
2. Hit it automatically or manually.
3, according to the circuit diagram check to correct.
4, the new generator or a long time do not use the machine easily appear. Press the control screen recharge button magnetizing, or 12V battery can be used to magnetize the field winding, the positive electrode is connected to F1, the negative electrode is connected to F2. If it is still unable to establish the voltage, Replace the battery positive and negative poles and try again.
5, cleaning is the surface of the ring, sanded carbon brush end surface and the arc surface of the collector ring surface match area greater than 70%, to strengthen the spring pressure.
6, clean carbon brush and carbon brush holder so that carbon brush can move freely.
7. Use a multimeter to check the forward and reverse resistance of the diode. If it is damaged, replace it.
8, check with a multimeter, if the forward and reverse resistance does not meet the requirements of the diode characteristics change.
9. Check the windings of generator set with multimeter 1K file. If the resistance is infinite, it should be connected. Use 1 euro file again. If the resistance is zero, replace or process the winding. If it is not stable, check if the connector wiring is loose.
Generator does not generate power failure and causes:
1, the control panel indicates that the voltage meter is bad
2. The "Automatic-Manual-Electromagnetic" switch on the control panel is in the de-energized position (automatic generator set function).
3, wiring error.
4, no residual magnetic or residual magnetic too low.
5, carbon brush and slip ring poor contact or brush spring pressure is not enough (three wave brush motor).
6, carbon brush holder rust or toner carbon brush stuck to the carbon brush can not move up and down (three wave brush motor).
7. The rectifier 2 on the excitation rectifier board is open-circuited or freewheeling diode short-circuit (three-wave brushed motor).
8, damaged rotary rectifier module.
9, generator winding or excitation winding broken or bad contact.
Overview:
The equipment is a transfer device that uses negative pressure and dust collection and is suitable for the opening and feeding of transit materials in the production process. The pulp can be stored first and then transported, effectively increasing the delivery volume. Used in combination with a dust collection system to avoid flying dust from traditional feeding.
Features:
The feeding station has a simple structure and is easy to operate.
The conical part of the silo is equipped with a vibrator to help the flow of material.
The screening system can be installed in the silo to prevent the caking material from clogging the discharge opening and conveying pipe.
In order to improve product quality, appearance and size may change.
Dustless Feeding System
Dustless Feeding System,Dustless Convey Feeding Hopper,Dustless Convey Feeder
Changzhou Ruide Drying Engineering Technology Co., Ltd , http://www.rddryer.com