The use and maintenance of car seat belts and head restraints must not be sloppy


In the process of learning to drive, the coaches will emphasize to the trainees the need to adjust the seats and fasten the seat belts, because the details of driving and using the car will affect our driving safety. Let's take a look at the precautions of the driver when he/she rides, such as the “safety belt” and “car headrest” that can save lives when an accident occurs.

The height of the headrest affects the driving of the vehicle. Our head does not normally leave the headrest, but the height of the headrest rests on the headrest, and the middle of the headrest aligns with the middle of the head. When adjusting the position of the car's headrest, adjust the height of the headrest to the occupant's eyes or the upper edge of the ear, and the distance between the hindbrain and the headrest of the car should be as close as possible, preferably no more than 10cm. Maximize the neck safety of occupants.

The adjustment of the correct driving position may seem simple, but it is the basis of safe driving. Once an emergency situation occurs, the correct driving position and correct driving posture will allow you to respond most quickly. The headrest of the car provides comfortable feeling for the occupants, and can better protect the neck safety of the occupants in the event of a traffic accident. For example, in the event of a crash, such as a car rear-end collision, it will have a huge impact, causing the driver's head to throw back violently. In this case, the fragile neck is easily injured and even causes fatal injuries. If the car headrests are placed correctly, they can protect the occupants in traffic accidents and avoid injuries to our neck and head.

The seat belt is properly secured. 1. After checking the safety of the seat belt, adjust the sitting posture. The distance between the person and the steering wheel is preferably that the two hands are placed on the steering wheel just after stretching with both hands; the legs are bent about 90 degrees, so that if the emergency brake is applied, the legs are more flexible, and when a collision occurs, it is ensured. The legs are adequately cushioned to prevent injury to the straddles and upper body. 2, adjust the seat belts. Hold the buckle lock and lock tongue and slowly pull out the belt around the waist to ensure that the shoulder belt slides across the shoulders, close to the neck, and fits snugly and snugly against the body. The waist belt is below the abdomen and should be as low as possible. It should also fit the body. Then, insert the seat belt buckle into the buckle until you hear the click sound.

In the process of wearing a seatbelt, the three-point lumbar seatbelt should be fastened as low as possible, be tied to the hips, and not be tied to the waist; shoulder harnesses should not be placed under the arm and should be placed diagonally in front of the chest. Seat belts can only be used by one person. Do not share; do not distort the seat belt. 3, adjust the seat belt according to body. After the seat belt is fastened, it should not be too loose or too tight. It is reasonable to leave a two-finger amount and it is not too uncomfortable to ensure safety. When you are pregnant, take care not to put your seatbelt on your stomach. This is very dangerous for the unborn baby. If a child under the age of 12 often rides in the car, the parents try to install a child safety seat.

Seat belt maintenance should pay attention to many drivers think that the seat belt is "pulled over, buckle up" on the line. In fact, the correct belt strapping method should be pulled from the middle of the left shoulder clavicle, the height must not be lower than the shoulder.

In the daily maintenance of the car, the maintenance of the seat belt is often overlooked. Normally, the performance of the seat belt should be checked frequently. If any damage is found, it should be promptly replaced. All fixed seats on the floor next to the seat and the seat belt bolts should be tightened as required. Sealants should be applied around the bolts. When the seat belt is dirty, use soft soapy water as a cleaning solution and scrub it with a cloth or sponge.

If your car's seat belt has been subjected to a strong straightening load during use, it should be replaced even if it is not damaged. Do not continue to use it.


Frosted Satin Ice Acrylic Sheet

Frosted Satin Ice Acrylic Sheet,Frosted Acrylic Sheet,Frosted Acrylic Panels,Frosted Unbreakable-glass Sheets

Jiangmen Kunxin new Material Technology Co.,Ltd , https://www.jmkunxinplastics.com